SolidWorks Integrator
SolidWorks Integrator is a module to synchronize data between SolidWorks and the Siqnal
modules Bill Of Materials and BOM lines. The procedure is that
once SolidWorks is started and an assembly is loaded, the BOM from SolidWorks, including
the Parts and Assemblies tree, can be copied to a new Siqnal BOM. If it already
exists from a previous transfer, it will be located automatically and updated.
In Siqnal all parts must be matched to
Siqnal articles, as shown further down this page, and once data are saved and
Siqnal is closed, the BOM and BOM line data are transferred to SolidWorks on
the "Custom" tab.
Screenshot from SolidWorks before data
transfer to Siqnal Bill Of Materials and BOM Lines:
Screenshot from Siqnal BOM Lines where
articles are matched using Match Article to match BOM lines from SolidWorks:
Screenshot from SolidWorks after Part data
are transferred from Siqnal BOM Lines:
Screenshot from Siqnal Bill Of Materials
where data from SolidWorks assembly are edit:
Screenshot from SolidWorks after Assembly data
are transferred from Siqnal Bill Of Materials:
